Technical information

FMS/BCS Z-WAVE RECEIVER - 5201001812
Including a FMS/BCS receiver into a Z-wave controller network:
Steps:
1) select channel on the controller by pressing the select button
2) press include/exclude button with a pin, green led on remote will light up
3) press the channel up or down button to activate the channel
4) press 3x quick the UP button on the Z-wave receiver, green led on remote
blinks once
5) press stop button on controller, including is completed.
Keep the Z-wave remote next to the Z-wave receiver during these steps.
Excluding a FMS/BCS receiver from a Z-wave controller network:
Press and hold the include/exclude button with a pin (~6 sec.) until the red led
on the remote lights up. Press 3x quick the UP button on the Z-wave receiver.
The green led on the remote will blink once. Excluding the Forest Shuttle is
completed. Keep the Z-wave remote next to the Z-wave receiver during these steps.
green led red led
UP/OPEN button
STOP button
DOWN/CLOSE button
include/exclude button
11/2010 WDOC5201001812 www.forestgroup.nl
34