Technical information

STEPS TO SET THE LIMITS
OF THE FMS MOTOR
Preferably set the limits of • Ensure that the two buttons on the bottom of the motor are visible,
the motor with the motor in a by removing the white cap of the motor (2A).
hanging position. Ensure that • Ensure that the two coloured wheels (on the photo depicted as white
the Master Carriers of the system yellow- white wheels) are in a neutral position. The position in which
are in the open position, meaning the indentations in each of the three wheels are in line. This is called
the intended position where you the “zero-situation” (2C). The motor comes standard with this setting.
want the master carriers to stop
when the curtain is open.
• Switch on the power
• Press and turn one of the buttons to find out which button you need to set
the masters in closed or open position
• Because you already moved the masters in the open position you only have
to select the setting wheel for the closed position
• Press and turn the selected button until the masters have reached the
intended ‘closed’ position.
• Turn off the power. Press and turn the selected button again to set back the
white-yellow-white wheels in the neutral position. You have set the limits now.
• To save the settings put the safety clip in the middle position.
In order to check if the settings are correct, Now close the system again and you will see that it
move the masters by using the remote or stops automatically where you have set the limits as
the wall switch to the open and closed described in step 3.
position.
If, for example, the masters are not fully
closing in the middle you have to reset
this position.
30