Technical information

POTENTIAL FREE RELAY 5201002230

With this relay 230Vac control signals (for FMS or tubular motor) can be converted to two potential free

contacts. These potential free contacts can be used to control Forest Shuttle motors.

Control voltage 230Vac Technical specification:

Input voltage: 230Vac, 50Hz

Output: two potential free contacts

Current consumption: 10mA (relay up)

Switching power: max. 8A, 250Vac

Temp: 0°C - +60°C

Terminal: max. 2,5mm²

Dimensions: 20 x 47 x 51

to Shuttle manual input (pin 1, 3 and 8) or

When the 230Vac control signal is not a pulse signal: change the manual input setting of the Shuttle(s) with a

programming IR remote like shown below. Aim the remote control to the IR eye.

To set this you need: programming IR remote (5201002250) and IR receiver (5201001260).

Note: when the Forest Shuttle is reset to default by means of the configuration button on the Forest Shuttle,

then the manual input setting is also reset to default (not stop on manual input release).

04/2011 WDOC5201002230 www.forestgroup.nl