Technical information

Shuttle manual input features

The default setting of the manual input of the Shuttle:

- pulse connection between pin 3 and 1 → system OPENS,

- pulse connection between pin 3 and 8 → system CLOSES.

Manual input of the Shuttle can be programmed different with a Shuttle IR programming remote 5201002250

and a Shuttle IR receiver 5201001260:

1) SPST : pulse connection between 3 and 8: OPEN STOP CLOSE STOP

2) STOP on SPDT manual input release (in case when pulse contacts are not available):

- connection between pin 3 and 1 → system OPENS until connection is released,

- connection between pin 3 and 8 → system CLOSE until connection is released.

3) Swap OPEN and CLOSE on SPDT, invert SPST:

Reset manual input features

Note: manual input features are also reset to default setting when the Shuttle is reset to default by means of configuration button on

Shuttle motor.

04/2011 WDOC SHMANINPUT www.forestgroup.nl