Technical information

SHUTTLE PULSE WALL SWITCH - 5201001900
CONNECTING THE WALLSWITCH
Either of the 2 ports (1-EYE or 2-AUX) can be used to connect a (pulse) switch to open, close or stop the
drapery. This is called a dry contact connection.
Pins 1, 3 and 8 are used for this. If pins 3 (common) and 1 (open) are connected by means of the switch then
the drapery will OPEN. If pins 3 (common) and 8 (close) are connected then the drapery will CLOSE.
A standard network cable can be used for this, connect only 3 wires to the wall switch. When the copper wire
is too thin to connect, use a ferrules, like:
Internal pins 1 and 8 are not connected between ports 1 and 2. Use a splitter to ‘daisychain’ Shuttle motors.
These ports can also be used for home automation systems. Be sure the switching (relay) outputs are dead!
(free of potential).
8 3 1 8 3 1
11/2010 WDOC5201001900V1.2 www.forestgroup.nl
24