Technical information

Programming IR channels on Forest Shuttle
To program a Forest Shuttle to a different channel you need a 12 channel IR remote control
(5201002250).
The default setting of the Forest Shuttle is channel 1.
To programming a Forest Shuttle put the connector of the IR module in port 1-eye of the Forest Shuttle
that you want to program. Remove the IR module from other Forest Shuttles in the same room, otherwise
the other Forest Shuttles will be programmed too.
Aim the remote control to the IR eye.
For re-programming to channel 2 press the next buttons on the remote control:
1) 2) 3) 4) 5)
press 3 buttons
simultaneously
For programming to channel 3 to 5 press the same buttons as above, this button represents the channel
number. Channel 3: button OPEN3, channel 4: button OPEN4, channel 5: button OPEN5.
When after re-programming you want to change the channel again: follow the same steps as above, only
at step 2) use the previous re-programmed channel number.
For example: the Shuttle is re-programmed to channel 2, this must be channel 3 → press next buttons:
OPEN7+CLOSE7+STOP → OPEN2 → CLOSE1 → OPEN3 → STOP
The ALL-buttons will open and close all channels.
It is also possible to use universal remote controls (like Logitech, Phillips, Sony, One for All) to control the
Forest Shuttle. It must be a learnable remote. Follow the instructions of the universal remote control.
Note: when the Forest Shuttle is reset to default by means of the configuration button on the Forest Shuttle, then the IR channel is
also reset to default (channel 1).
04/2011 WDOC PROG IR SH www.forestgroup.nl
23