Technical information

SCENE SETTING WITH Z-WAVE REMOTE

Scene setting (intermediate positions) on a Shuttle track can only be use in combination with the Forest

Z-wave remote. All 3 scenes can be set in the full range between open and close.

NOTE: In order to make the scene setting work correctly, make sure that the curtain track is assembled in the way as shown

below, to aviod changing the motor direction of the Shuttle. Also make sure the open and close limits are set.

press open/close buttons press include with pin, press the desired scene press button press stop button

to select desired position green led will light up button, associated led on receiver to finish

of the curtian will blink

For setting scene 2 and 3 use the same steps as above, only change scene button 2 or 3. Associated leds (2 or 3) will blink.

In case of 5 Shuttles, the scene buttons can be used as ‘ALL’ – buttons. Program every Shuttle open position to scene 1, close

position to scene 2. Then scene 1 button is the ‘ALL OPEN’ – button, scene 2 button is the ‘ALL CLOSE’ – button.

05/2011 WDOC SCENE SET www.forestgroup.nl