Technical information

Z-WAVE REMOTE / RECEIVER

INCLUDING THE SHUTTLE IN A Z-WAVE NETWORK*:

select channel press include with pin, press button activate channel press button press stop

green led will light up on receiver on receiver to finish

EXCLUDING THE SHUTTLE FROM A Z-WAVE NETWORK*:

press include/exclude red led will light up press button on receiver green led will blink twice

button ~6sec.

COPY UNIQUE REMOTE ADDRESS TO 2ND REMOTE*:

remote1 remote 2

press include of 1st press open and stop of led 1 to 5 will blink fast,

remote with a pin 2nd remote simultaneous address of remote1 is

now copied to remote 2

* Keep the remote close to the receiver/2nd remote (max 0,5 mtr).

In case of a 3rd party remote/receiver, consult the corresponding manual.

To reset a (second) copied remote to its origional unique address, press and hold the SELECT ▲ and ▼ buttons simultaneously

for ~5 seconds until all 7 leds light up.

Note: in case receiver/remote does not respond, reset receiver to default by pressing the button on the receiver for ~5 seconds until red

led lights up. Then try again to include.

04/2011 WDOC ZWAVE www.forestgroup.nl