Instruction manual

Appendix A – Product Specific BCS Commands
38
Instruction Manual – BCS Basic Control Structure Protocol
8Y-3000 (continued)
Audio Commands (for systems that support digital gain and volume control)
If the 8Y-3000 supports digital control of audio signals, it supports the following audio commands.
Digital output volume control – absolute, relative, and increment/decrement methods
(see page 13)
Verifying volume status (see page 15)
Muting and un-muting outputs (see page 14)
Digital input gain control – absolute, relative, and increment/decrement methods (see page 16)
Verifying digital input gain status (see page 18)
Auxiliary Commands
Precis 6x2
Precis 6x2 models support the following items:
General Commands
Executing and disconnecting switches (see page 6 and page 7)
Verifying signal status (see page 8)
Specific Commands and Conditions
If the Level “L” designation is omitted, the command is executed on the default level, which is
Level 0 (audio-follow-video). To route video or audio signals separately, enter Level 1 for
video only or Level 2 for audio only
The Precis 6x2 with a front control panel will accept BCS commands while the panel is
locked, but BCS commands cannot be used to unlock the front panel
The Precis 6x2 is equipped with a Standby switch. During Standby mode, BCS commands
cannot be entered
Does not support audio commands
Does not support global or local preset commands
Does not support auxiliary commands
Supports limited error code reporting. An “E” appearing as the result of a Status command
indicates a communication failure between the CPU and the control panel. To establish
communication, use the control panel to execute a switch or power down and then power up
the system
Auxiliary Commands Supported by 8Y-3000
To cause a warm reboot ~app!
To view a long splash screen with advanced system information ~scr!