Instruction manual

Adjusting and Verifying Audio with DSP
23
Instruction Manual – BCS Basic Control Structure Protocol
Verifying DSP Command Status
The status for DSP command settings will display in parentheses ( ). Balance results are a percentage of
the pan right (positive number) or pan left (negative number). Gain results for tone bands and for
equalization bands are decibel amounts specified as a decimal number to the tenth place without the
decimal point. For example, if the result is -480, the decibel level is at -48 or if the result is 65, the
decibel level is at 6.5.
Note: Multiple levels or outputs cannot be entered in status commands.
To verify the balance setting of an output:
1.
Enter the following command string. Replace the “#”s with the output number.
SO#PT
To verify the gain of a tone band for an output:
1.
Enter the following command string. Replace the “#”s with the output number and tone band (filter)
number.
SO#F#T
To verify the gain of an equalization band for an output:
1.
Enter the following command string. Replace the “#”s with the output number and EQ band.
SO#E#T
DSP Command Status Examples
BCS Command Status Result Explanation of Result
SO3PT SO3PT( 100 )
Verifies the balance of Output 3 is set 100% to the right
SO2PT SO2PT( -33 )
Verifies the balance of Output 2 is set 33% to the left
SO6F1T SO6F1T( -120 )
Verifies the bass band for Output 6 is at -12 dB
SO3F3T SO3F3T( 90 )
Verifies the treble band for Output 3 is at +9 dB
SO17E1T SO17E1T( 90 )
Verifies the gain of EQ band 1 is set to +9 dB for Output 17
SO4E1 2 3T SO4E1 2 3T
(
60 -90 -120 )
Verifies the gain of EQ band 1 is set to +6 dB, band 2 is set
to -9 dB, and band 3 is set to -12 dB for Output 4