Specifications

Wiring and Device Connections

Enova AVX-400 Cat5 Presentation Switcher Operation/Reference Guide

Composite Output (VIDEO)

The composite output enables you to use a composite cable (RCA Y) to send video to a display device like a

projector. Attach the composite cable to the composite video connector on the rear of the presentation switcher

and run the other end of the cable to the Composite connector (normally yellow) on the display device or to a

Composite wall input plate. If you connect the port to a wall input plate, use an RJ-45 cable to connect the port

on the rear of the wall input plate to one of the source input ports on the front of the switcher.

HD-15 Output Connectors

Each AVX-400 has two HD-15 output connectors. The outputs enable you to use an HD-15 to COMPONENT

or HD-15 to RGB/VGA cable to send video to a display device such as a projector or large screen monitor. The

output device displays video from source input devices routing through the AVX-400-SP. There is one output

each for COMPONET and RGB/VGA sources. The following table lists the pinout configuration for HD-15

connector to RGB/VGA connectors:

FIG. 25 Composite output

FIG. 26 HD-15 Output connectors

Video Output HD-15 Connector Pinouts

Pin Signal Function

1 Red Red signals

2 Green Green signals

3 Blue Blue signals

4N/C

6 RGND Red analog ground

7 GGND Green analog ground

8 BGND Blue analog ground

10 SGND Synchronization analog ground

13 HSYNC Horizontal synchronization signal

14 VSYNC Vertical synchronization signal

12345

678910

11 12 13 14 15