Specifications

Wiring and Device Connections

Enova AVX-400 Cat5 Presentation Switcher Operation/Reference Guide

Preparing Captive Wires

You will need a wire stripper and flat-blade screwdriver to prepare and connect the captive wires.

1. Strip 0.25 inch (6.35 mm) of insulation off all wires.

2. Insert each wire into the appropriate opening on the connector (according to the wiring diagrams and

connector types described in this section).

3. Tighten the screws to secure the wire in the connector. Do not tighten the screws excessively doing so

may strip the threads and damage the connector.

Wiring a Power Connection

To use the 2-pin 3.5mm mini-Phoenix connector with a 12 VDC-compliant power supply, the incoming PWR

and GND cables from the external source must be connected to their corresponding locations on the connector

(FIG. 18). Follow these steps to wire a power connection:

1. Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm mini-Phoenix cable. Match the

wiring locations of the +/- on both the power supply and the terminal connector.

2. Tighten the clamp to secure the two wires. Do not tighten the screws excessively. Doing so may strip the

threads and damage the connector.

3. Verify the connection of the 2-pin 3.5 mm mini-Phoenix to the external 12 VDC-compliant power supply.

Installing a Suppression Ferrite

Never pre-tin wires for compression-type connections.

FIG. 18 2-pin mini-Phoenix connector wiring diagram (direct power)

Power Supply

PWR +

GND -

If you are in a location with 240V of power, you must clip the supplied Suppression

Ferrite around the Power cable (no tools required).

FIG. 19 Installing the Suppression Ferrite

1. Release the latch to open

the plastic enclosure.

2. Insert the power cable

and close the enclosure.

3. Installation complete.