Specifications

Programming
150972 7-29
Fail Attempts
This feature specifies the number of times the dialer should attempt to perform the dial/switch
sequence before issuing an account trouble condition. Range is 01 - 15 (Default = 10).
13. Enter the number of fail attempts (or press the or arrow), then press .
Selecting Primary and Secondary Phone Lines
For each account, select which phone line (Line 1 or Line 2) is primary. See Figure 7-11 for
an example of how to make this selection.
14. Press the or arrow to select line 1 or 2 as primary phone line, then press .
15. Repeat step 14 for the secondary phone line.
Telephone Number
Enter up to 40 characters for phone number for this account.
The following special characters are available:
Use the number buttons on the annunciator or the up- and down-arrow keys to select special
characters. Characters begin displaying after "9". See Figure 7-11 for an example.
Table 7-8: Special Character for Dialing
# Pound (or number) key on the telephone
* Star key on the telephone
, Comma (character for 2-second pause)