Specifications

Programming
150972 7-21
Internal and
External 5815
(Continued)
SWITCH
(Continued)
PAS_ AC K
Positive acknowledge switch. This switch
must be used in zones programmed as Positive
Alarm Sequence (see Table 7-2).
If an acknowledge switch closes when an
alarm or trouble condition is not already in
progress, a trouble will occur.
You must use a UL listed normally open,
momentary switch type. The switch must be
rated at 5V, 100 mA (minimum) and be used
with an EOL resistor for supervision.
ZN_AUX1
Latching Use these switch types if you want to monitor
special zone-level conditions (such as
operation of a fan or damper).
Non Latching
ZN_AUX2
Latching
Non Latching
SYS_AUX1
Latching Use these switch types if you want to monitor
special system-wide conditions (such as
operation of a fan or damper).
Non Latching
SYS_AUX2
Latching
Non Latching
DETECT SW
Used to monitor conventional 4-wire detectors,
a contact closure will generate a detector alarm
event.
TAMPER
Latching Performs identically to a supervisory switch,
but will be indicated as a tamper switch on the
LCD annunciator.
Non Latching
NOTIF
OUTPUT PT Select Group
Output Point, a general use notification type.
Use for driving standard notification
appliances.
AUX CONST Select Group
Use constant power for applications that
require a constant auxiliary power source.
Power is always present at Constant circuits.
AUX RESET Select Group
Use for auxiliary power, resettable
applications. See Section 4.13.3 for a
description of how this option operates.
AUX DOOR Select Group
Use for auxiliary power, door holder
applications. For example, if you were using
an auxiliary power supply for door holders,
you would use this option. See Section 4.13.1
for a description of how this option operates.
RELAY
OUTPUT PT Select Group
Output Point, a general use relay type. Use for
applications requiring a relay, such as fan
shutdown, elevator recall, and so on.
AUX RESET Select Group
Use for auxiliary power, resettable
applications. See Section 4.13.3 for a
description of how this option operates.
AUX DOOR Select Group
Use for auxiliary power, door holder
applications. For example, if you were using
an auxiliary power supply for door holders,
you would use this option. See Section 4.13.1
for a description of how this option operates.
Table 7-6: Point Programming Options for 5815 Modules
Module Type
Type
Selection
Function
Latching
Option
Comments