Specifications
Programming
150972 7-13
7.3 Group
An output group is made up of output points that have been programmed to respond in the
same way. Output groups simplify programming because you do not have to program each
individual point. Once you have defined the characteristics of output groups, you can assign
each point to the appropriate group. Up to 250 output groups can be defined.
7.3.1 Edit Group
In the edit group option you can program the name of an output group (Section 7.3.1.1) and
change the properties (Section 7.3.1.2) of that group.
To edit a group, follow these steps:
1. Enter the installer code.
2. Press to display the installer menu.
3. Select for Program Menu.
Display reads: ,QLWLDOL]LQJ
3OHDVHZDLW
4. Press to enter group menu.
5. Press to edit group.
6. Enter the number of the group you wish to edit, then press .
7.3.1.1 Edit Group Name
7. To edit the group name, press .
A screen similar to the one in Figure 7-7 will display. Select a one- or two-word
descriptive name as shown in the diagram. Refer to Appendix B Section B.1 for a list of
available words.
7
3
1
1