Specifications

Control Panel Installation
150972 4-33
4.12.2.2 Class A Inputs
You can connect conventional Class A switches, such as waterflow switches and pull stations,
directly to the I/O circuits of the 5820 control panel.
To install a Class B switch:
1. Wire the Class B switch as shown in Figure 4-33.
2. Configure the circuit through programming (see Section 7.4).
Figure 4-33 Class A initiating Switches
Note: In programming any point that uses multiple I/O circuits are always referred to as the lowest I/O circuit
number used. For example, Figure 4-33 uses both I/O circuit 5 and 6, so in programming it would be
referred to as point 5.
Note:
I/O circuit 5 and 6
used as an example.
Any I/O point pairing
could be used.