Specifications

Control Panel Installation
150972 4-5
3. Run extended battery cable from 5820 cabinet through conduit to AB-33 cabinet.
See Figure 4-5.
Figure 4-5 Battery Connections in the AB-33 Cabinet
Note: Any one of the cabinet knock-outs (on either the 5820 or the AB-33 cabinet), that are not previously being
used may be utilized to connect conduit between the two cabinets.
4. Connect battery leads to the backup battery terminals. See Figure 4-5.
Observe the proper polarity to prevent damage to the batteries or the control panel.
5. Insert the AB-33 cover screws into the cover mounting holes (see Figure 4-5).
Screw the cover screw 3/4 of the way into the cover mounting hole.
6. Align the cover plate mounting keyhole over the cover mounting screws. See Figure 4-6.
Figure 4-6 Cover Plate Mounting Keyholes and Cover Mounting Screws Alignment
7. Slide the cover into place and tighten the cover mounting screws. See Figure 4-6.
Conduit
Conduit
Coupler
+
+
-
-
AB-33 Cabinet
Cover Screws
AB-33 Cabinet
Cover Screws
Cover Plate
Mounting Keyholes