Technical data

Digital Brushless AC servo drive system - Ref.0707 MCSi-67/84
Function: Its purpose is to correct the possible difference in analog
command generated to obtain exactly the same speed in both
turning directions.
Function: Parameter SP20 and SP21 set the necessary ratio between
the analog command and the motor speed. They correspond
to the reference of the CNC concept G00 Feed.
Function: See parameter SP20.
Valid values: 10, ..., Motor rated speed (rev/min).
Default value: Motor rated speed (rev/min).
Function: Correction of the analog velocity command offset It is applied
after the analog input is treated by SP19, SP20 and SP21.
Valid values: - 2000, ..., + 2000 (rev/min)x10
-2
.
Default value: 0 (rev/min)x10
-2
.
SP19 BASIC, RW SymmetryCorrection
Valid values: - 500, ..., + 500 mV
Default value: 0 mV.
SP20 BASIC, RW VoltageRpmVolt
Valid values: 1.00, ...,10.00 V.
Default value: 9.50 V.
SP21 BASIC, RW RpmRpmVolt
SP30 BASIC, RW VelocityOffset
SP19
SP20
SP1
V
SP21
rev/min