Installation guide

Section 4 - Programming – Service Functions 73
Note: Similarly as in other SATEL control panels, shorting the pins and
powering up alone will not restore any parameters. However, it will
activate the service mode thus making it possible to check how the
control panel has been programmed, and to analyze any programming
errors.
REMOTE PROGRAMMING – DLOAD10
The DLOAD10 program delivered with the control panel is designed for programming
the CA-5, CA-6, CA-6 plus, CA-10 and CA-10 plus panels, as well as the RX2K and
RX4K radio controllers, from the computer. Additionally, the program makes it
possible to create documentation of alarm systems, sets of settings for various
configurations ("patterns" which facilitate the programming of new systems), event
sets for each system, as well as to remotely operate the control panel in the same
way as with the keypads.
The program is designed for IBM PC/AT compatible computers. It works in any
computer hardware configuration in the WINDOWS (9x/ME/2000) environment. It is
recommended that the program be installed on the computer hard disk.
The control panel communicates with the computer through the RS-232 interface or
via the telephone line. For telephone communication with the panel, the program
uses a modem controlled by one of the COM ports (internal or external), compatible
with the HAYES "AT Command" standard. Communication with the control panel is
possible in the CCITT V.21 or BELL 103 standard (at 300 Bps). As the control panel
transmits data only with a speed of 300 bauds, the modem must support this speed
of operation.
Usually a suitable modem configuration is necessary - disabling the transmission
standard negotiating function and forcing the transmission speed of 300 Bps.
In order to install the program, run the D10setup.exe program from the floppy disk
which is delivered with the control panel. The installation completed, start the
program . Access to the program is protected with an access code. After installation,
the code is 1234 and can be changed to any sequence of 16 alphanumeric
characters. As long as it has its factory form, you can start the program (with default
code 1234) by pressing the „ENTER” key (no access code need to be entered).
Having started the program, configure and initialize the work of RS-232 port or
modem by means of which the control panel will be programmed. By default, the
program opens a window which enables the CA-10 plus panel to be programmed.
Your next step can be starting the connection (either remote or local).
A HELP system is provided which facilitates operating of the program, as well as the
very programming of control panel parameters. The system is accessible from the
„HELP” menu, or by pressing the F1 key on computer keyboard. To get an instant
access to more detailed information, first select the required element in the program
window (by moving the mouse pointer to and left-clicking on it), and then press the
F1 key.
Program configuration for communication with the panel
In order to begin configuration, click on the
icon to open the „Configuration”
window. The „Port RS-232” tab permits selecting the computer port number
in the case of direct programming through the panel RS port. If the control
panel is being programmed by means of the modem, select the „Modem” tab and
click on the „Details” button.