Installation guide

62 Functions Programming Dialer
FS-88 - programming telephone number 2 (HEX)
FS-89 - programming telephone number 3 (HEX)
FS-90 - programming telephone number 4 (HEX)
FS-91 - programming telephone number 5 (HEX)
FS-92 - programming telephone number 6 (HEX)
FS-93 - programming telephone number 7 (HEX)
FS-94 - programming telephone number 8 (HEX)
The functions FS-87 to FS-94 are used to program the telephone numbers to
which the control panel sends alarm messages. Each telephone number can have
up to sixteen digits and special characters. The numbers are to be programmed in
the same way as in the function FS-4.
FS-95 - programming assignment of partitions and messages (BIT)
Reporting alarm messages depends on which partition is alarming. The function
FS-95 associates telephone numbers with partitions and defines which message
is to be sent. The programming consists in indicating, for each telephone number,
the partition number and the number of message to be sent.
Programming in the LED keypad:
• telephone number (1 to 8, binary) shown on LEDs 9 – 12
• LEDs 1 to 4 show the assignment of consecutive numbers to partitions:
1 - telephone number for partition 1
2 - telephone number for partition 2
3 - telephone number for partition 3
4 - telephone number for partition 4
• LEDs 5 to 8 show the message sent to a consecutive number:
5 - message 1 for paging system
6 - message 2 for paging system
7 - message 3 for paging system
8 - message 4 for paging system
Note: If no message for the paging system is assigned to the number, the panel
will send a voice message from the synthesizer.
EXAMPLE:
programming of the following settings (assuming that LEDs 1 to 8 for all numbers are
off)
•
1
st
telephone number -voice message from synthesizer, with alarm in partition 1,2, 3,
•
2
nd
telephone number - message No. 2 (pager), with alarm in partition 1,
•
3
rd
and 4
th
tel. number - voice message from synthesizer, after alarm in partition 3
•
other numbers not used
[9][5][#] - call the function (LED 12 is blinking - 1
st
number)
[1][2][3] - LEDs 1, 2 & 3 go on (number 1 assigned to partitions 1, 2 & 3)
other LEDs are off
[#] - confirm assignment for number 1 (LED 11 is blinking - 2
nd
number)
[1] - LED 1 goes on (number 2 assigned to partition 1)
[6] - LED 6 goes on (message 2 assigned to number 2)
[#] - confirm assignment for number 2 (LEDs 11, 12 are blinking - 3
rd
number)
[3] - LED 3 goes on (number 3 assigned to partition 3)
[#] - confirm assignment for number 3 (LED 10 is blinking - 4
th
number)
[3] - LED 3 goes on (number 4 assigned to partition 3)
[#] - confirm assignment for number 4 (LEDs 10, 12 are blinking - 5
th
number)
[
*
] - exit the function. As for the other numbers all the LEDs 1 to 8 are off, the control
panel will not dial those numbers.