Installation guide

60 Functions Programming System Event Codes
Functions Programming System Event Codes
Apart from the events from zones and partitions, the CA-10 plus panel can transmit
information on 24 system events (mainly related to the detected troubles).
The codes of these events may consist of single or double characters. For the data
formats 4/1 and 3/1, one character must be equal to 0. Information on the events
whose code has been programmed as 00 is not reported to the stations.
FS-81 - programming system event codes - set I (HEX)
The function enables the first sixteen out of 26 system events to be programmed.
The programming procedure is same as in FS-69.
Number LEDs 9-12 status Event
1 {{{ AC loss
2 {{{ AC restore
3 {{ Low battery
4 {{{ Battery restore
5 {{ Output OUT1 trouble
6 {{ Output OUT1 restore
7 { Output OUT2 trouble
8 {{{ Output OUT2 restore
9 {{ Output OUT3 trouble
10 {{ Output OUT3 restore
11 { Printer trouble
12 {{ Printer restore
13 { Enter service mode
14 { Exit service mode
15  Start DOWNLOADING
16 {{{{ End DOWNLOADING
FS-82 – programming system event codes - set II (HEX)
The function enables the other eight system events to be programmed.
The programming procedure is same as in FS-69.
Number LEDs 9-12 Event
1 {{{ Output OUT4 trouble
2 {{{ Output OUT4 restore
3 {{ Transmission problems
4 {{{ Event log overflow
5 {{ Loss of time
6 {{ RAM memory fault
7 { System restart
8 {{{ Test transmission
9 {{ Keypad power supply trouble
10 {{ Keypad power supply restore
Notes:
• The code 3 is recorded in the event log when the control panel is unable to
establish communication with the station. In that case, the control panel will
retry after 120 seconds to establish connection. When it gets through, the
control panel will transmit all events from the memory. The "transmission
problems" code item makes it possible to asses when the oldest event
occurred. The events are sent by the panel in the order of their occurrence
(the oldest event is sent first), unless the event sorting mode is active. In
such a case, the zone events are sent first, then the partition events, and
the system events are sent last.