Installation guide

58 Functions Programming Zone Event Codes
No. LCD LED Option
ON
send ZONE ALARM code
1
OFF
do not send ZONE ALARM code
ON
send ZONE TAMPER ALARM code
2
OFF
do not send ZONE TAMPER ALARM code
ON
send ZONE TROUBLE ALARM code
3
OFF
do not send ZONE TROUBLE ALARM code
ON
send ZONE VIOLATION ALARM code
4
OFF
do not send ZONE VIOLATION ALARM code
ON
send ZONE RESTORE code
5
OFF
do not send ZONE RESTORE code
ON
send ZONE TAMPER RESTORE code
6
OFF
do not send ZONE TAMPER RESTORE code
ON
send ZONE TROUBLE RESTORE code
7
OFF
do not send ZONE TROUBLE RESTORE code
ON
send "ZONE BYPASSED" & "ZONE UNBYPASSED" codes
8
OFF
do not send "ZONE BYPASSED" & "ZONE UNBYPASSED" codes
Functions programming partition event codes
FS-69 - programming partition 1 event codes (HEX)
FS-70 - programming partition 2 event codes (HEX)
FS-71 - programming partition 3 event codes (HEX)
FS-72 - programming partition 4 event codes (HEX)
In each partition, the control panel distinguishes fifteen events, whose codes are
programmed separately for each partition (functions FS-69 to FS-72).
The partition event codes can be single- or double-character. For the data formats
4/1 and 3/1, one of the characters must be equal to 0, and the mode of extension
by the user number should be deactivated (see FS-47 "Monitoring options ").
When the event codes are to be double-character ones, the panel can extend
some codes with the user number (for the events enabling the user to be identified
by the access code). The codes which are to be extended should be programmed
as single-character ones (one character must be equal to 0). Additionally, the
mode of extension by the user number should be activated.
The code of event caused by the MASTER user is extended by "F", the codes of
other users – by "1"..."C". Where the partition is zone controlled, or quickly armed
with the [0][#] function, the event code is extended by "D". When the event is
caused by the clock (see the "Functions programming TIMERS"), the event code
is extended by "E".
Programming the 00 setting means that we omit sending event information to the
station.
The programming consists in assigning two characters (from 0 to F) to each
partition event and confirming them. When programming, the keypad LEDs 1 to 8