Installation guide

40 Functions Programming Basic Parameters
will dial the number until it gets through. Only when the number has been
dialed in full, the busy or no answer condition will change the counters.
• If shorter than 16 characters, the telephone number must be ended with
the special code AA (double „AA” means end of number).
• Special signals generated in the DTMF system require two characters to
be taken up in the telephone number (A and a corresponding digit).
• In the LCD keypad, the DTMF special signals are entered by
programming the A character and a corresponding digit, according to the
above meaning.
EXAMPLE: programming the number 0 - 556 40 31 (0D 55 64 03 1AA)
[4] [#] - call the required function
[0][
*
3] [#] - enter the two first characters
[5][5] [#] - enter the two next characters
[6][4] [#] - enter the two next characters
[0][3] [#] - enter the two next characters
[1][
*
0] [#] - enter the next character and the part of special code AA (telephone number end)
[
*
0] [#] - enter the second part of special code AA (telephone number end)
[
*
] [#] - exit the function after entering 11 characters.
FS-5 - programming the system options (BIT)
The function programs three sets of options which define the control panel
operating mode (for the LCD keypad, it is one list of 24 options).
FIRST SET OF OPTIONS (for LED keypad, the LED No. 12 is blinking)
No. LCD LED
Option
ON
telephone messaging
on
1
OFF
telephone messaging
off
ON
monitoring
on
2
OFF
monitoring
off
ON
call answer
on
3
OFF
call answer
off
ON
printing
on
4
OFF
printing
off
ON
CR+LF mode (printer)
on
5
OFF
CR+LF mode
off
ON
transmission rate to printer
2400 Bps
(RS-232)
6
OFF
transmission rate to printer 1200 Bps
ON
transmission to printer
with parity
(RS-232)
7
OFF
transmission
without parity
ON
transmission to printer with
EVEN
parity
8
OFF
transmission with
ODD
parity
Note: The options 4 to 8 of the first set refer to the control panel operation with
a printer.