Installation guide

38 Service Functions of the LCD Keypad

Key Numeric mode Text mode

deletes character before cursor changes character into previous in alphabet

switches "change – add" modes changes character into next in alphabet

1 1 . ,

2 2 A a

3 3 D d

4 4 G g

5 5 J j

6 6 M m

7 7 P p

8 8 T t

9 9 W w

0 0 space -

The text mode is signaled by the * character situated in the right upper corner of

the display. In the text mode, the numeric keys will bring letters to the cursor

position, as shown in the table above. The lower case letters are obtained by

pressing the numeric key twice. When the function is in the numeric mode, it is

possible to terminate programming of the text by pressing in turn the keys [

] and

[#].

CONTROL PANEL SERVICE FUNCTIONS

FS-0 - exiting service mode

Pressing the [0][#] keys calls the service function 0, which ends the control

panel operation in service mode. The control panel starts functioning in

accordance with the new settings. Restart of all partitions is performed - if any

keypad operations are carried out at this moment in another partition (e.g. if a

user function has been activated), the panel will terminate the current function

and enter the standby state. Exiting the service mode is signaled in all partitions

with four short and one long beeps.

Functions programming basic parameters

FS-1 - changing service code

The service access code enables activation of the service mode. It can be from

4 to 6 digits long.

EXAMPLE:

changing the service code from 12345 to 78901

[12345] [#] - enter the service mode

[1] [#] - call the service function 1

[78901] [#] - enter the new code and confirm it; the function will be automatically exited.

FS-2 - programming control panel identifier (HEX)

FS-3 - programming computer identifier (HEX)

After establishing connection with the computer in the DOWNLOADING mode, the

panel sends a six-character system identification code and waits for the code of

the answering computer. When the correct identification code is received,

transmission to the computer may begin.