Installation guide

36 LED Keypad
of digit pairs (binary). The programming consists in entering a two-digit number
and confirming it with the [#] key. The control panel will confirm acceptance of the
datum with two short beeps. When all the parameters have been programmed,
the function is exited which is signaled with four short and one long beeps.
The [
*
] key makes it possible to quit the function at any time without saving the
changes in currently displayed data.
HEX Functions
The functions are used to program hexadecimal data (e.g., monitoring codes).
When running the function program, the LEDs 1-4 show the first hexadecimal
digit, LEDs 5-8 - the second digit, while the LEDs 9-12 display the counter of digit
pairs.
Programming by means of this type of function consists in entering a parameter
(two hexadecimal digits) and confirming it with the #] key. For the digits 0-9 it is
sufficient to press the corresponding key, the digits A-F are entered using the
combination of keys [
*
] and [0]-[5] (i.e. A=[
*
][0], B=[
*
][1] etc.). Pressing the [
*
] key
results in blinking of the digit, which will be changed after one of the keys [0]-[5] is
pressed.
The [
*
][#] combination of keys makes it possible to exit the function without saving
the changes in the currently displayed data.
Note: Both in the decimal and hexadecimal function, consecutive depressions
of numeric keys result only in displaying the respective number on the
LEDs (the state of LEDs 1-4 and 5-8 is alternately changed). Only by
pressing the [#] key you will save the status of the parameter displayed on
the diodes .
Figure 12 shows how to read data
from the keypad LEDs. The sixth
parameter is being programmed
(counter = 6), LEDs 1-8 indicate
current value of the parameter
equal to A2 (HEX).
Figure 12
Programming with the LCD Keypad
After entering the service code and pressing the key [#] or [
*
], the control panel
enters the service mode. It is signaled in the LCD keypad by alternate blinking of the
LEDs ALARM and PARTITION1 and appearance of the message:
Pressing any arrow key will display the service mode hierarchical menu, which
facilitates access to the service functions. The menu is built so as to group the
particular panel service functions by subjects.
Service mode
Menu:
ÇÈÅÆ
123
4
56
78
9
*
0
#
1
2
3
4
5
6
7
8
9
10
11
12
ALARM
ARMED
FAILURE
8
4
2
1
8
4
2
1
1 digit
2 digit
counter