Installation guide

30 Installation Guide CA-10 plus SATEL
Telephone messaging - alarm reporting.
The telephone messaging function requires that the following be programmed:
• FS-5, FS-131 – activate the “telephone messaging” option, set the “dialing
system” option as required by the telephone exchange,
• FS-87 to FS-94 - enter at least one telephone number,
• FS-95 – define the partitions from which alarms are to be reported to the
telephone numbers programmed in functions FS87-90,
• FS-100 – number of telephone messaging queues higher than zero and
number of redials in a queue.
Note: You should also program in FS-95 what kind of message will be sent - if no
message is selected for the pager, the control panel will notify with a voice
message from the voice synthesizer.
When the above parameters are correctly programmed and the alarm is triggered,
the on-board LED (designated as „DIALER”) should go on, which indicates that the
panel has started telephone messaging (with pulse dialing the LED is blinking). It is
recommended to test the messaging. To this purpose, use the ordinary headset
connected to the „telephone line monitoring” jack in the SM-2 synthesizer (parallel
connection of a telephone set to „monitor” the communication will interfere with the
messaging operation). The telephone messaging will start immediately after
triggering the alarm. Alarm clearing will interrupt the telephone messaging.
Typical problems with starting the voice messaging:
• control panel takes no attempts to call – not all of the above mentioned
items were programmed ;
• control panel goes on line but fails to dial – no dial tone or a non-standard
dial tone from the telephone exchange – find out the cause of missing signal or
deactivate the dial tone test option in FS-5 if the signal is non-standard;
• control panel establishes connection, but sends no voice message –
wrongly programmed FS-95 – messaging to pager selected, but not voice
message from the synthesizer;
• control panel establishes connection, sends a message too early or too
late – the control panel recognizes answering the call on the basis of sound
signals on the telephone line, with permissible message sending delay up to 4
seconds from lifting the handset - if commutation signals on the telephone line
are non-standard or there is strong interference (clicks, hum), the panel
automatic equipment may not function properly – then you can extend the
message by activating the “double message” option in FS-5 or deactivate the
call answer recognition option;
• control panel reports the alarm more times than the preprogrammed
number of queues – the control panel recognizes answering the call on the
basis of a callback signal – if the user lifts the handset too quickly (during the
first ring), the control panel may disregard the message and call again.
Reporting to Telephone Monitoring Station
The monitoring station operator should provide the installer with the data necessary
for the monitoring software. These are:
• monitoring station telephone numbers
• transmission format or a list of available formats