Specifications

CV10 Touch Panel Accessories
31
10" Modero Widescreen Touch Panels
8. Slide the rear battery locking slider in the opposite direction. This turns the latching mechanism and
secures the panel to the base.
9. Upon successful connection, the AMX logo appears on the panel to indicate that the panel is
properly connected and receiving power.
Charging the NXT-BP using the NXA-BASE/1
1.
Insert the single battery into the battery compartment shown in FIG. 30 on page 31.
2. Follow the procedures from the previous sub-section to attach the NXT-CV10 to the NXA-BASE/1.
3. Insert a 2-pin connector from a power supply to the rear PWR connector on the NXT-CV10 Modero
panel. Refer to the Battery Base Page section on page 98 to view the charging progress of the
connected NXT-BP.
FIG. 30 NXA-BASE/1 showing Panel Interface and connector locations
FIG. 31 NXA-BASE/1 shown aligning with NXT-CV10 panel
Panel Interface
connector (male)
Securing
pegs (2)
Front
Back
Battery
locking
mechanism
Battery
locking slider
Insert holes for
NXT-CV10 feet
Alignment
pegs (2)
(Battery not shown
for illustration purposes)
Alignment
pegs
Battery
locking
mechanism
(with locking
slider)
The battery base CANNOT be hot-swapped. An NXT can not be receiving power
(through a connected power supply) and then be connected to a battery base.
Always POWER OFF the panel before installing the NXA-BASE/1.