Specifications

CV10 Touch Panel Accessories
30
10" Modero Widescreen Touch Panels
2. Charge the NXT-BP battery by either inserting it into the battery base or from within the optional
NXT-CHG charger (which can sequentially charge up to two batteries).
Installing an NXT-BP into the NXA-BASE/1
The base does not directly connect to a power supply. Instead, it receives the power necessary to charge
the battery from the Modero panel (through the Panel Interface connector).
1. Install the NXT-BP battery into the base’s battery compartment with the label-side facing up.
2. Align the battery connector with its corresponding battery connector port (located in the battery
compartment shown in FIG. 29).
3. Carefully insert the NXT-BP into the base until the battery securely fits onto the Battery Connector
Port.
Installing the NXA-BASE/1 below an NXT-CV10 Panel
1.
Power Off the panel before attempting to attach the NXA-BASE/1.
2. Place the battery base (with battery) onto a flat/level surface.
3. Turn the battery locking slider (FIG. 30) to one side until the locking mechanism is horizontal to the
base (going left to right) and the rear battery latch is pointing directly outward (away from the
LCD).
4. Carefully angle the NXT-CV10 panel over the front alignment pegs (FIG. 31). The pegs assist in
both aligning and securing the panel to the base (the locking mechanism secures the base to panel
when done).
5. Insert the alignment pegs into their corresponding holes below the front of the panel.
6. Verify the alignment of the Panel Interface connectors between the panel (female connector) and
base (male connector) (FIG. 31).
7. Align the rear pegs and gently push the rear of the panel downwards until it is mounted atop the
battery base.
It is recommended to fully charge this battery before using it to power an NXT-CV10
panel. If the 25% LED indicator is blinking, recharge your battery immediately.
This blinking indicates there is less than 5% of a charge remaining on the battery.
FIG. 29 Battery installation
NXT-BP Battery
Battery
Connector
Battery
Connector
Port
FRONT