Instruction manual

47
10. CONNECTING TO EXTERNAL DEVICES
1. Power OFF the OS. Connect the OS and
computer using the USB cable.
C "9. POWER ON/OFF"
$
• The computer does not need to be turned OFF
before connection.
2. Press { } while pressing {ENT} to dislay a
message box asking whether to boot USB mode,
then press [YES].
The screen of the instrument will be <USB Mode>.
$
• OS may not be displayed as <Removable Disk>.
It depends on Windows settings.
G
Follow the instructions below to ensure that the
OS continues to operate normally during USB
transfer.
• Do not change the folder hierarchy or folder
names in <Removable Disk>.
• Do not format the "removable disk" on the
computer.
3. Perform "Safely Remove Hardware" in the
task bar and disconnect the USB cable.
4. Press {} and hold (about 1sec) to turn off the
instrument to exit USB mode connection.
I Mobile mode connection
A synchronous software needs to be installed to the computer dependhing on the Windows
version.
1. Power OFF the OS. Connect the OS and
computer using the USB cable.
C "9. POWER ON/OFF"
$
• The computer does not need to be turned OFF
before connection.
Computer to connect Synchronous software
Windows XP ActiveSync
Windows vista/7 Windows Moblle Device Center