User`s guide

Section 6 – Displaying and Using the Point Description CONFIG Screens
6.2 Profit Optimizer’s DQP/RMPCT Configurations
1/00 Profit Optimizer User's Guide 75
Honeywell Inc.
Field Descriptions
Table 6-1 DQP/RMPCT Configuration – Understanding the Fields and Using the Targets
DQP/RMPCT Configuration – Field Descriptions and User Notes
Field
Description
Field Type Default Access
User Notes
RMPCT Controller
Point
Target ENG
Tag names of the Profit Controller points that
the optimizer sees.
Optimizer point must be
inactive to enter a tagname.
For Open installations,
leave this entry blank if
RMPCT is not on the same
LCN as DQP.
RMPCT Appl Side
Interface Point
Target ENG
The interface point located in the same unit
as the Profit Controller point. It is used to
transfer data between the controller and the
optimizer.
Optimizer point must be
inactive to enter a tagname.
For Open installations,
leave this entry blank if
RMPCT is not on the same
LCN as DQP.
DQP Appl Side
Interface Point
Target ENG
The interface point located in the same unit
as the Profit Optimizer point. It is used to
transfer data between the controller and the
optimizer.
Optimizer point must be
inactive to enter a tagname.
For Open installations, fill
this entry in but note that
the RMPCT Appl Side
Interface Point and DQP
Appl Side Interface Point
should be blank if RMPCT
resides on a different LCN
than DQP.