User`s guide

Error! Style not defined.
4.2 Profit Optimizer’s DQP CV Detail Display
50 Profit Optimizer User's Guide 1/00
Honeywell Inc.
Profit Optimizer’s DQP CV Detail – Field Descriptions and User Notes
Field
Description
Field Type Default Access
User Notes
Lo Limit Ramp Rate
Target ENG
Sets the rate at which the Active low limit
ramps to meet a new [LO LIMIT].
• Whenever the Active low limit is below the
Operator-set low limit, the Active limit ramps to
the new limit by the specified rate at each
execution.
• Ramping occurs when the low limit is raised or
the setpoint is changed.
Hi Limit Ramp Rate
Target ENG
Sets the rate at which the Active high limit
ramps to meet a new [HI LIMIT].
• Whenever the Active high limit is above the
Operator-set high limit, the Active limit ramps
to the new limit by the specified rate at each
execution.
• Ramping occurs when the high limit is lowered
or the setpoint is changed.
Unbiased Model PV
Read-Only No Access
The uncorrected, raw, predicted value. The
value without a mathematical bias applied.
To get an idea of the accuracy of your model, trend
the unbiased model PV against the actual PV.
RMPCT Appl #
Read-Only No Access
The Profit Controller (RMPCT) application
number associated with the optimizer.
CV #
Read-Only No Access
The RMPCT CV.
Linear Obj Coef
Target ENG
Linear objective coefficient. An optimization
parameter.
There are three different versions of this parameter:
• Profit Controller (RMPCT) (view only)
• Profit Optimizer (DQP)
• User
Quad Obj Coef
Target ENG
Quadratic objective coefficient. An
optimization parameter.
There are three different versions of this parameter:
• Profit Controller (RMPCT) (view only)
• Profit Optimizer (DQP)
• User
Desired CV Val
Target ENG
Desired resting value for the CV during
quadratic optimization.
There are three different versions of this parameter:
• Profit Controller (RMPCT) (view only)
• Profit Optimizer (DQP)
• User (view only)