Specifications

Common Setup Ver. 0002 GSU - 7
GSU.7 INITIALIZATION PROCESS
Turning the Drive causes it to Reset. This reset may also be caused by the user:
• By means of the push-button located on top of the drive module.
• With the SoftReset command of the portable programmable module.
• At the WinDDSSetup program using the [GV11] Soft Reset command. See figure.
This Reset has the following effect:
• The Status Display shows the initialization sequence.
• The data stored in the Flash memory (parameters and variables defining its
configuration) go into RAM memory, and from it into the internal memory.
• The data is cross-checked and verified.
• Any detected errors are indicated on the display of the face plate.
Error Reset.
If the system detects any errors, their cause must be removed and then, an "Error Reset"
must be done.
• Electrically, through pin X2(1) of the Power Supply (pin X2(3) at the Compact).
• Executing the command: [DC1] Reset Errors at the WinDDSSetup program.
There are errors considered as "non-resettable", See Appendix B.
These errors can only be eliminated by a Reset of the Drive.
Internal Memory
Flash Memory
PC RAM Memory
Non
Volatile
Reset