Specifications

GSU - 6 Common Setup Ver. 0002
GSU.6 SAVE INTO FLASH MEMORY
In order for the values given to the parameters during setup stay as a permanent Drive
configuration, they must be transferred into the Flash memory.
1st.- The Drive must be connected to power.
2nd.- Save the parameters
To do this, execute the command to save into Flash.
• At the WinDDSSetup, press the
button
• With the command ParametersToFlash of the portable programming module.
When it is done saving, the Status Display will display the OK message or the errors (if
any). Then, it requests whether the Drive is to be Reset or not.
3rd.- Then, the Drive should be Reset.
Flash Memory
PC RAM Memory
Non
Volatile
RAM to Flash