Specifications

EM - 52 Electronic Modules Ver. 0002
EM.10 PROGRAMMING MODULE, DDS PROG MODULE
The Programming Module is a small portable unit that could replace a PC for setting the
parameters and monitoring the system.
It is connected to the Drive module via the serial communications line. It can transfer
parameter tables, edit them when setting them, execute commands, monitor internal variables
and save that parameter table in its internal nonvolatile memory.
It can also be connected to a PC for transferring parameter tables.
Its electrical installation is limited to the connection of that serial communications line since it
receives the 5Vdc supply through it.
It may be built into any of the compact modules ACD or SCD. It can be mounted inside the
electrical cabinet onto
(32mm) or (35mm) type metallic rails.
It can be shown on the outside of the enclosure using a front adapter supplied by Fagor and
described in the last section of this chapter.
The last section of this chapter shows the
module dimensions.
Electrical connections:
Operating ambient temperature
5°C - 45°C
(41°F - 113°F)
Storage temperature
-25°C - 60°C
(-13°F - 140°F)
Relative humidity 80% max
Operating vibration 10..60 Hz, 0.1..5 G, 2 hr
Shipping vibration 60..300 Hz, 5 G, 2 hr
Sealing IP4x (IP5x front panel)
Weight 150 gr (0.330 lbs)