User Guide

Pre-Installation

AXC-TEMP Temperature Control Card and RTS1 Room Temperature Sensor

RTS1 Preparation

To install the RTS1 units:

1. Wire RTS1 units 1 - 4. Refer to Wiring the RTS1 for additional information.

2. Check the temperature.

! If the panel has a display, check the temperature readings on the system Wiring control

panel. The temperature readings will change when the room temperature changes by a

half degree.

! If the panel does not have a display, check the variables in Axcess.

Wiring the RTS1

Use Belden 8723 or equivalent cable. When an application or code requires plenum-rated cable, use

Belden 88723 or equivalent cable.

Call AMX Technical Support for any installations that require a wire run of more than 100 feet.

FIG. 6 RTS1 circuit connections

2.75" (69.9 mm)

w/ front cover on

4.5"

(114.3 mm)

RTS1 backplate

Wire feed hole

RTS1 circuit board

AXlink connector

From left to right:

GND, OUT, PWR

RTS1 depth is 0.9"

(22.9 mm) with the

front cover installed