Instruction manual

ERROR MESSAGE TABLES 24
6.1 Error message table
NOTE: If an error is not rectified by taking the suggested action, if it is erratic or persists without apparent cause, disconnect the power supply
and contact the service engineer.
ERROR MESSAGE EXPLANATION EFFECT ON MACHINE OPERATOR ACTION
INVALID The parameter entered is
not valid i.e. minutes >59
Machine will not run 1. Press CE to clear error
2. Re-enter parameter
BAD ID Rotor has not been
identified or rotor not fitted
Machine will stop
Error cannot be cancelled until motor
has stopped turning
1. Press CE and open lid
2. Check rotor has been fitted
3. Remove rotor, clean drive head and top
surface of motor
4. Clean and inspect rotor bore and underside of
rotor
BADROTOR Rotor identified should not
be fitted to machine
Machine will stop
Error cannot be cancelled until motor
has stopped turning
1. Check that the rotor is correct for the machine
2. Remove rotor, clean drive head and top
surface of motor
3. Clean rotor bore and underside of rotor
4. Check rotor magnets are not missing or
damaged
SET>MAX The speed set is greater
than is allowed for rotor
Machine will run at maximum speed
for rotor
1. Press CE to clear error
2. Reset speed once run has ended
IMBALNCE Rotor assembly is not
balanced within allowable
limits
Machine will stop
Error cannot be cancelled until the
rotor has stopped turning
1. Press CE and open lid
2. Ensure rotor buckets pivot freely
3. See 5.4 Loading the rotor and 5.5 Balancing
the rotor
4. Remove rotor and clean drive head and rotor
bore