Instruction manual

HOW TO USE YOUR HARRIER 18/80 21
5.8.7 Entering acceleration and brake rate
To change the acceleration and brake rate press the ACCEL/BRAKE key. The
brake display will flash and read “SETACCEL”. Enter the acceleration rate and
press ACCEL/BRAKE again. The display will read “SETBRAKE”. Enter the
brake rate. If an error is made press CE and re-enter the value. Once the
correct values have been entered press ACCEL/BRAKE again, and the display
will stop flashing. The status will read “READY”.
Figure 10 Acceleration and brake rate curves
5.9 Starting the run
Ensure that the rotor is correctly loaded and fitted. Close the lid and press down
firmly to engage the lid lock. Press the rotor start key. The display will now
change to show actual values of speed, run time and brake rate. During the run
the status display will read “ROTOR ID”. The status of the unit is ramp up at
speed and stopping. At the end of the run an audible bleep will be heard.
5.10 Code Key
The code key can be used to lock and unlock the key pad. To do this press the
code key. The status will display “CODE” press 1, 2 & 3. The status will read
“LOCKED”. When the keypad is locked only the Start and Stop keys will
operate.
The code key can also be used to change the language displayed in the status
window. To do this press the code key followed by the appropriate code as
shown below:
000 for English
001 for French
002 for German
004 for Portuguese
006 for Danish
007 for Turkish
008 for Hungarian
009 for Romanian
010 for Estonian
5.11 Manual termination of run.
At any time the run may be stopped by pressing the
(STOP) key.