Unit installation

Appendix C: Additional Workstation Configuration Information
Altera Corporation 289
If you are using the Bourne or Korn Shell, environment variables are located
in your .profile file, and have the following format:
set <environment variable>=<value>
MAX2_HOME
The MAX2_HOME variable specifies the name of the MAX+PLUS II home
directory. The default is /usr/maxplus2. You should use this variable only if
the system displays an error message indicating that MAX+PLUS II files
cannot be found when you start the program.
MAX2_PLATFORM
The MAX2_PLATFORM variable specifies the name of the platform used to
run MAX+PLUS II. You should use this variable only if the following error
message is displayed when you start the program: Unable to determine the
type of system you are using.
The following table lists the supported MAX+PLUS II platform names and
corresponding variable values:
MWCOM1, MWCOM2, MWCOM3 & MWCOM4
These variables control the mapping of serial ports in MAX+PLUS II, which
MAX+PLUS II accesses by the names COM1 through COM4, to the
corresponding UNIX serial tty ports. Table C-1 shows the default variable
values.
Platform Name: Variable Value:
SPARCstation running SunOS 4.1.3+ sunos
SPARCstation running Solaris 2.5+ solaris
HP 9000 Series 700/800 hp
IBM RISC System/6000 rs6000
81_GSBOOK.fm5 Page 289 Tuesday, October 14, 1997 4:04 PM