User manual

Phoenix
32
User Manual www.RealmCtrl.com
109
13.7.1. To change the Level 1 and Level 2 passwords, press [Passwords] and enter the
new access codes on the following page. Note that the Level 2 password is not
used at this time.
13.7.2. To change the chime that plays immediately before an announcement is made,
press [Announcement Chime] and enter the new Sound ID.
13.7.3. To clear an active Security Lockdown, press [All Clear]. More information
pertaining to the Lockdown event will follow in this document.
13.7.4. To enter the maintenance area of AMS, press [Maintenance Menu]. The options
provided on the maintenance page vary according to site and are typically
applicable only to Realm Control technicians.
13.7.5. To cycle power on the AMS Head End equipment, press [PA], [RF], or [MEDIA].
These are toggling buttons.
13.7.6. To ramp volume for the PA, media, music, or bells, ramp the bargraphs
accordingly.
13.8. To logout of AMS from any page, press the padlock in the lower left-hand corner.
13.9. Telephone remote control
Some facilities include the ability to control AMS and make announcements by dialing in
from a telephone. The following describes the process by which the telephone control
feature can be used:
13.9.1. To make an announcement using the telephone:
• Dial the telephone number for the Telephone Remote Access interface and
enter the password followed by a pound (#) sign.
Note: the telephone number and password will be provided separately.
• Press 1 at the Main Menu to go to the Public Address Sub-Menu.
• Press 1 at the Public Address Sub-Menu to start the Public Address.
• Wait until you hear the audible tone that indicates the system is ready. This
tone will be unique to your facility.
• Make the announcement.
• Press 2 to stop the Public Address.
• Press the asterisk (*) to hang up, or simply hang up the phone.