User manual

Phoenix
32
User Manual www.RealmCtrl.com
105
13.3.7. Restoring the bell schedule
Press [Reload] to restore the bell schedule to a previously saved version. Any new
events that were added since the previous save will be lost.
13.3.8. Press [Clear All] to completely reset the bell schedule. This will clear the active
schedule and will also delete it from the internal NetLinx disk. AMS will prompt for
confirmation. It is important to be absolutely certain before acknowledging this
command.
13.3.9. Press [Sort List] to sort the bell schedule chronologically.
13.4. Section 2: Public Address (PA)
13.4.1. To create a PA zone, press an available PA Destination and then click [Edit
Name]. A keyboard will surface that will allow entry of a descriptive name.
13.4.2. To configure the zone(s) that the PA should reach, press [Edit Zone]. This will
cause AMS to display the Keymap. Assign rooms to the PA zone just as one would
configure a manual bell event, described above.
13.4.3. To start a PA event, press [MICROPHONE ON]. The status area will advise
when the broadcast is ready by displaying the “PA LIVE” prompt. To end the
announcement, press [MICROPHONE OFF].