User manual

Phoenix
32
User Manual www.RealmCtrl.com
104
Configure the scheduled bell event in same manner as the manual bell event. Use
the Bell Schedule day/time page to assign the desired weekday and time to the bell
event. Note that bell events configured with a frequency of “Once” will only activate
one time. Those configured as Repeating will occur weekly and will be shown on
the event list with an (R) suffix.
After configuring the bell event day/time, sound, and zone, press [Enable Event] to
activate it.
13.3.4. Run a bell schedule
To run a bell schedule, press the desired schedule name within the “Run Bell
Schedule” section. Press it again to stop it.
13.3.5. Adjust the bell volume
Use the Volume bargraph to increase or decrease the bell volume. This is a global
setting that should be tweaked to an optimal level for all bells.
13.3.6. Saving the bell schedule
Any events that are created on the bell schedule will be lost if the system is
rebooted unless the [Save] button is pressed first. Press [Save] after the entire bell
schedule is configured. That will store the schedule on the internal disk within the
NetLinx control system.