Technical data

CommandTouch User’s Handbook F-7
The red TX1 LED indicates that the CommandTouch Panel is transmitting data to the
codec. The red RX1 LED indicates that the codec is transmitting data to the
CommandTouch Panel. Depending upon the codec software release, the codec may or
may not send signals to the CommandTouch panel.
The red TX2 LED indicates that the CommandTouch panel is transmitting data to the
Numonics tablet. The red RX2 LED indicates that the tablet is transmitting data to the
CommandTouch panel. If the pen is placed on the tablet surface, the RX2 LED will
remain lit as the tablet sends data continuously. This is a normal operating condition.
If there are serious problems which can not be resolved after contacting your
authorized service representative, you should disable the CommandTouch option in
order to use the AppsView interface.
Deactivate the CommandTouch option by resetting the pointing device configuration
setting. Follow the steps for configuring the TC System for CommandTouch, but in
Step 2, deactivate the VTEL CommandTouch option box. If no checkmark is
displayed, then the option is disabled. Continue with Steps 3 and 4.
If the deactivation is temporary, the CommandTouch hardware may
remain installed on your system.