Technical data

F-2 CommandTouch User’s Handbook
Even though you installed the system software, you still must now download the
CommandTouch Version 1.1 software onto the touch panel. To complete the
download, follow these steps:
1 Exit AppsView by moving your mouse pointer to the letter V in the lower right
corner of the screen and clicking the right mouse button. Select “Exit AppsView
immediately” with the left mouse button.
2 Select Shut Down from the Start button on the Windows 95 Taskbar; then select
“Restart the Computer in MS-DOS mode”
Note: If the Windows 95 Taskbar is not visible to you, press <Ctrl> <Esc> on the
keyboard.
3 At the DOS prompt, type: cd \vtel\appsview
4 In the \vtel\appsview directory, type:ctload
CAUTION
If your CommandTouch has been modified in any way
(including VTEL ICS customizations), This upgrade will
permanently destroy these changes. Please contact your
system integrator before proceeding with this installation. If
your CommandTouch has not been customized, then proceed
with this software upgrade installation.
5 Follow the on-screen instructions or refer to this document to proceed with the
upgrade.
6 Disconnect cable 605-1441-01 (or its equivalent) from the COM1 port on the TC
codec. See Figure F-1 for an illustration of the cables that you need to disconnect.
7 Locate the 9-pin to 9-pin download cable and plug either end into the COM1 port
on the TC codec.