Technical data

1 Locate the AXB-EM232 Enhanced Master box and rack mount assembly.
2 Locate the cable labeled AMX CONTROLLER” at the codec end of the umbilical cable.
(There is a 4-pin captive compression-style connector on the end of the cable.)
Connect the cable to the AXlink port on the backpanel of the AXB-EM232 Enhanced
Master box.
3 Locate the cable labeled “605-1440-01.” Plug the end with the 6-pin captive
compression-style connector into the 6-pin RS232 port on the backpanel of the
AXB-EM232 Enhanced Master box.
4 Locate the cable labeled
“605-1441-01.” Plug the
end with the 8-pin
captive compression-
style connector into the
port labeled “RS232/
422” on the backpanel of
the AXB-EM232
Enhanced Master box.
5 Locate the PS2.8 power supply. Plug the power supply’s green 2-pin connector into the port
labeled “PWR” on the backpanel of the AXB-EM232 Enhanced Master box.
6 Open the rear cabinet door and install the AXB-EM232 Enhanced Master box and rack
mount assembly in the first rack position below the cabinet shelf. (Make sure there is enough
room for all four rack mount screws to be installed.)
7 Locate the 4-pin captive compression style connector at the table end of the umbilical cable.
The cable is labeled “TOUCH SCREEN” and connects to the CommandTouch panel. Locate
the door flap on the back side of the touch panel base. Inside there are three connectors.
Connect the cable to the 4-pin connector labeled “AXlink.”
8 Remove the cable connected to the Com 1 port on the codec backpanel. Connect this cable to
the 9-pin RS232 connector on cable 605-1440-01.
9 Connect the 9-pin RS232 connector on cable 605-1440-01 to the Com 1 port on the
backpanel of the codec.
10 Set the PS2.8 power supply on the shelf inside the cabinet. Plug the PS2.8 power cord into
the switched power strip inside the cabinet.
You have now completed the CommandTouch hardware installation on the TC.