Instruction manual

Programming

AXB-PT10/30 PosiTrack Camera Controllers

The following table lists the error values you can get when diagnosing any problem.

If there are any errors found, the

230

error value displays that there is an error, and is then followed

by another number to indicate the precise problem. For example, a problem with the Pan Encoder

will return the message:

230

240

Preset parameters and commands

The following table lists the preset parameters.

Error Values and Descriptions

Error Description

230

Shows there is an error on the system. This value always appears in conjunction with another num-

ber. It acts as a precursor to any other error messages, as an announcement that an error has

been found and the following values are the errors found.

240 Shows that there is a problem with the Pan Encoder on the PosiTrack. The encoder is a device that

counts the revolutions of the pan motor.

241

Shows that there is a problem with the Tilt Encoder on the PosiTrack. The encoder is a device that

counts the revolutions of the tilt motor.

242 Shows that there is a problem with the Pan Optical reader on the PosiTrack. The reader is a device

that detects the home position of the pan gear.

243 Shows that there is a problem with the Tilt Optical reader on the PosiTrack. The reader is a device

that detects the home position of the tilt gear.

244 Shows that there is a Worm ECC error (pan) on the system. This error occurs when the worn gear

is not fitting properly along the pan’s gears.

245 Shows that there is a Worm Eccentric error (tilt) on the system. This error occurs when the worm

gear is not fitting properly along the tilt’s gears.

246

Shows that the pan stalled. Occurs when the pan motor locks up.

247 Shows that the tilt stalled. Occurs when the tilt motor locks up.

Preset Parameters

Preset 1-255

TIME: (Optional)

If specified, 0 to 255 in tenth seconds. If not specified, at

current rate. Used for voltage outputs. Used only for recall

preset.

SPEED: (Optional) 0 to 127. 0 is slowest and 127 if fastest. If not specified, at

current speed. Used for Motor Drive outputs, including

pan/tilt control. It is used to Recall Preset only.