Instruction manual

Programming
32
AXB-PT10/30 PosiTrack Camera Controllers
Configuration Commands (Cont.)
TILT CURVE= INVERT
Adjusts Tilt Up/Down
speed curves for
inverted mounting posi-
tion.
Syntax:
SEND_COMMAND CAM,"’TILT CURVE=INVERT’"
This keeps the up and down tilts moving at the same rate for a given speed.
(Added v1.10)
Sets the tilt curve to inverted, for inverted installation position. This command
reverses the direction of the tilt motor.
ZAP!
Initializes all memory in
the unit.
Syntax:
SEND_COMMAND CAM,"’ZAP!’"
This includes speed settings, deviation settings, configuration settings, and all
presets.
ZOOM PRESET=POS
Sets the Zoom voltage
output to recall posi-
tional presets (default).
Syntax:
SEND_COMMAND CAM,"’ZOOM PRESET=POS’"
This is applicable only if the ZOOM SIGNAL=S command is in effect, and the
ZOOM switch is set to the S position (servomotor mode). The command for
ZOOM output to servomotor mode or motor mode MUST be configured to match
the switch settings.
ZOOM
PRESET=SPEED
Sets the Zoom voltage
output to recall speed
presets.
Syntax:
SEND_COMMAND CAM,"’ZOOM PRESET=SPEED’"
This is applicable only if the ZOOM SIGNAL=S command is in effect, and the
ZOOM switch is set to the S position (servomotor mode). The command for
ZOOM output to servomotor mode or motor mode MUST be configured to match
the switch settings.
ZOOM SIGNAL=S
Sets the Zoom output
to be a servomotor out-
put.
Syntax:
SEND_COMMAND CAM,"’ZOOM SIGNAL=S’"
This setting corresponds to the S position (servomotor mode) setting on the
ZOOM switch. The command for ZOOM output to servomotor mode or motor
mode MUST be configured to match the switch settings.
ZOOM SIGNAL=M
Sets the Zoom output
to be a motor output.
Syntax:
SEND_COMMAND CAM,"’ZOOM SIGNAL=M’"
This setting corresponds to the M position (motor mode) setting on the ZOOM
switch. The command for ZOOM output to servomotor mode or motor mode
MUST be configured to match the switch settings.
ZP
Sets the lens’ Zoom
mode to positional
(default).
Syntax:
SEND_COMMAND CAM,"’ZP’"
This command can be used only for servomotor mode.
The ZP command applies only if you connect pin 6 (zoom), 7 (focus), and/or 9
(iris) to the lens control connector. These pins determine if the lens is in posi-
tional or speed mode.
ZS
Sets the lens’ Zoom
mode to speed.
Syntax:
SEND_COMMAND CAM,"’ZS’"
This command can be used only for servomotor mode.
The ZS command applies only if you connect pin 6 (zoom), 7 (focus), and/or 9
(iris) to the lens control connector. These pins determine if the lens is in posi-
tional or speed mode.