Instruction manual

Programming
27
AXB-PT10/30 PosiTrack Camera Controllers
Configuration Commands (Cont.)
CLEAR ERRORS
Clears all of the error
messages obtained by
using the
DEVICE
STATUS
command in
the Terminal Emulator
mode within the
AxcessX program.
Syntax:
SEND_COMMAND CAM,"’CLEAR ERRORS’"
Refer to the Diagnostic error values section on page 39 for detailed information.
CLEAR HOME
Clears the current
home position and
goes to the default
setting and clears
presets.
Syntax:
SEND_COMMAND CAM,"’CLEAR HOME’"
This command is used within the AxcessX program.
This command clears all presets.
CLEAR LIMIT ALL
Clears all of the limits
given and goes to the
default values.
Syntax:
SEND_COMMAND CAM,"’CLEAR LIMIT ALL’"
This command is used within the AxcessX program.
CLEAR LIMIT DOWN
Clears the tilt limit down
given and goes to the
default value.
Syntax:
SEND_COMMAND CAM,"’CLEAR LIMIT DOWN’"
This command is used within the AxcessX program.
CLEAR LIMIT LEFT
Clears the pan limit left
given and goes to the
default value.
Syntax:
SEND_COMMAND CAM,"’CLEAR LIMIT LEFT’"
This command is used within the AxcessX program.
CLEAR LIMIT RIGHT
Clears the pan limit
right given and goes to
the default value.
Syntax:
SEND_COMMAND CAM,"’CLEAR LIMIT RIGHT’"
This command is used within the AxcessX program.
CLEAR LIMIT UP
Clears the tilt limit up
given and goes to the
default value.
Syntax:
SEND_COMMAND CAM,"’CLEAR LIMIT UP’"
This command is used within the AxcessX program.
CURRENT SPEED
PRIORITY=CHANNEL
Changes the opera-
tional mode of channels
31, 32, 35, and 36.
Syntax:
SEND_COMMAND CAM,"’CURRENT SPEED PRORITY=CHANNEL’"
Does NOT allow pan/tilt movement from levels until these channels are turned
Off.
Setting this priority puts the unit in CaMatrix compatible mode. The CaMatrix is
an RS232 control program that runs on a PC.
CURRENT SPEED
PRIORITY=LEVEL
Changes the opera-
tional mode of channels
31, 32, 35, and 36.
Syntax:
SEND_COMMAND CAM,"’CURRENT SPEED PRORITY=LEVEL’"
Allows pan/tilt movement from levels even if these channels are still On.
Setting this priority makes the move at current speed channels operate like the
other axis movement channels.
DEFAULT ACCEL
Sets the Pan and Tilt
acceleration to the
default value of 90
degrees/(second
squared).
Syntax:
SEND_COMMAND CAM,"’DEFAULT ACCEL’"
This command is issued from the Terminal Emulator mode of the AxcessX pro-
gram.