Instruction manual

Installation
15
AXB-PT10/30 PosiTrack Camera Controllers
PT10 Camera/Lens Mounting and Balancing
The camera/lens assembly should be mounted so the tilt axis is capable of going through the optical
axis of the camera, assuming the optical centerline is between ½" (12.70 mm) and 5" (127.00 mm)
above the mounting plane of the camera lens. The mounting platform (camera cradle) allows the
camera/lens to be mounted with its center of gravity on the tilt axis. The maximum weight of the
camera/lens assembly is 10 lbs. (4.54 kg). The camera cradle is mounted to the Tilt Hub (FIG. 14).
To mount and balance the camera/lens:
1. Separate the camera mount and the cradle support bracket by removing the two ½" screws on
the underside of the assembly (see FIG. 15) using a 3/32 Allen wrench.
2. Install the camera alignment peg to the mount at the position tat best fits the camera/lens.
3. Secure the camera/lens to the mount (at the camera attachment peg) with the screw and
fastener supplied with the camera/lens (see FIG. 15).
FIG. 14
Tilt Hub dimensions for the PT10
0.750"
19.05 mm
0.750"
19.05 mm
0.750"
19.05 mm
0.750"
19.05 mm
0.250"
6.35 mm
0.250"
6.35 mm
0.00"
0.00"
Position
markers
Camera points
in this direction
0.56"
39.62 mm
Do not lift the PT10 by the Camera/Lens cradle as this procedure could damage
internal components.
FIG. 15
Camera bracket assembly
Camera mount
(underside view)
Camera bracket assembly
(side view)
Mounting holes
(three sets)
Cradle support
bracket
Camera
alignment peg