Instruction manual

Appendix A – EDID Programmer
113
Epica DGX 16 and Epica DGX 32 Instruction Manual
10. Save the board’s EDID default as a backup (assumes the board has factory default EDID
programming)
.
 Click the Refresh Display List button.
 Select the device.
 Click the Read button.
 Click the Save button (select location, enter file name, and click Save).
11. Click the Open button to select the .edid file to be written to the DVI input connector.
12. Click the Write button to write the EDID information to the DVI input connector.
13. If applicable – Repeat any of the steps that are necessary for any additional DVI input connectors.
14. Disconnect the DVI video cable from the PC and from the Epica DGX DVI Input Board.
15. Disconnect the serial cable from the PC and from the Epica DGX 16 or 32 enclosure.