Instruction manual

Control Panel Operation
76
Epica DGX 16 and Epica DGX 32 Instruction Manual
Setting the Password
The Epica DGX 16 and 32 Control Panel’s default password is “1 2 3 4 5” entered using the first five
input keys. A new password can be set using any combination of five of the Input Keys 1 through 8
when the LCD displays “Enter New PWD” (Step 5 in the following procedure). In the Change Password
Mode (selected in Step 4), the keys available to use in a password will illuminate blue.
If a password has been created and downloaded to the system from XNConnect, a new password can be
set from the front panel to replace it; however, the previous one must be entered first.
Caution: We strongly recommend recording the new password in a secure place; an
Epica DGX 16 or 32 system cannot retrieve a lost password.
If the password is lost while the system is locked, a new password can be set and downloaded to the
system using XNConnect (see page 121).
To set the password:
1.
Press the Function Key.
The Function menu appears.
2. Locate Setup Options by scrolling with the Control Dial.
3. Press the Select Key.
The Setup Options submenu appears.
Locate Change Password by scrolling with the Control Dial.
4. Press the Select Key.
The LCD displays the prompt Enter Current PWD.
Using the illuminated keys, input the current password. (The default password is 1 2 3 4 5.)
5. The LCD displays the prompt Enter New PWD.
Using any combination of the illuminated keys, input the new password.
(To change any entries, press the Cancel Key – restarting the process – and reenter from the start.)